Setting up to use TAPR: Difference between revisions
From WeatherWiki
No edit summary |
m (Added categories) |
||
(3 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
---------------------------------------------------------------- | ---------------------------------------------------------------- | ||
[http://www.tapr.net TAPR (Tucson Amateur Packet Radio)] provides a variety 1-wire weather sensor kits, including the following: | |||
* X1W-1 | |||
X1W-1 | * X1W-4 | ||
* X1W-4 | |||
and rain sensors or interfaces | * T-238+MODEM2 | ||
These kits provide temperature, humidity, barometer, radiation, lightning, and rain sensors or interfaces through the Dallas 1-wire system. | |||
[[Image:barometer.jpg]] | '''Programming X1W-1 Barometer''' | ||
# On the main Weather Display window, click '''Control Panel'''. | |||
# Under '''Station Settings''', click '''Dallas 1 Wire'''. | |||
# On the '''Main/Save Setup''' tab, in the '''Current Direction Chip ROM ID #''' box, select and then copy (press CTRL+C) the number to the clipboard. | |||
# Select the '''I have a barometer (Bray-Jennings or AAG)''' check box. | |||
# On the '''Barometer setup''' tab, in the '''Bray/Jennings Barometer ROM ID'''" box, paste (CTRL+V) the number you copied to the clipboard in step 3. | |||
# Enter values for the '''High Baro''', '''Low Baro''', '''High Voltage''', '''Low Voltage''' as follows: | |||
#* '''High Baro''' = 31.60 | |||
#* '''Low Baro''' = 25.69 | |||
#* '''High Voltage (volts)''' = 9.75 | |||
#* '''Low voltage''' = 1.75 | |||
#*; [[Image:barometer.jpg]] | |||
# Click '''Set'''. | |||
# On the '''Main/Save Setup''' tab, click '''Save/reset'''. | |||
# Click '''Close'''. | |||
After approximately five minutes, barometer sensor readings are captured. | |||
[[Category:Weather Display]] | |||
[[Category:Configuration]] | |||
[[Category:1-Wire]] |
Latest revision as of 14:20, 8 May 2022
TAPR (Tucson Amateur Packet Radio) provides a variety 1-wire weather sensor kits, including the following:
- X1W-1
- X1W-4
- X1W-4
- T-238+MODEM2
These kits provide temperature, humidity, barometer, radiation, lightning, and rain sensors or interfaces through the Dallas 1-wire system.
Programming X1W-1 Barometer
- On the main Weather Display window, click Control Panel.
- Under Station Settings, click Dallas 1 Wire.
- On the Main/Save Setup tab, in the Current Direction Chip ROM ID # box, select and then copy (press CTRL+C) the number to the clipboard.
- Select the I have a barometer (Bray-Jennings or AAG) check box.
- On the Barometer setup tab, in the Bray/Jennings Barometer ROM ID" box, paste (CTRL+V) the number you copied to the clipboard in step 3.
- Enter values for the High Baro, Low Baro, High Voltage, Low Voltage as follows:
- Click Set.
- On the Main/Save Setup tab, click Save/reset.
- Click Close.
After approximately five minutes, barometer sensor readings are captured.