Setting up to use TAPR: Difference between revisions
From WeatherWiki
(Standardized procedural steps; applied Wiki formatting styles; relocated image beneath step it refers to.) |
m (Removed number from last item which is not a step, but a conclusion statement.) |
||
Line 24: | Line 24: | ||
# On the '''Main/Save Setup''' tab, click '''Save/reset'''. | # On the '''Main/Save Setup''' tab, click '''Save/reset'''. | ||
# Click '''Close'''. | # Click '''Close'''. | ||
After approximately five minutes, barometer sensor readings are captured. |
Revision as of 17:20, 5 September 2010
TAPR (Tucson Amateur Packet Radio) provides a variety 1-wire weather sensor kits, including the following:
- X1W-1
- X1W-4
- X1W-4
- T-238+MODEM2
These kits provide temperaure, humidity, barometer, radiation, lightning, and rain sensors or interfaces through the Dallas 1-wire system.
Programming X1W-1 Barometer
- On the main Weather Display window, click Control Panel.
- Under Station Settings, click Dallas 1 Wire.
- On the Main/Save Setup tab, in the Current Direction Chip ROM ID # box, select and then copy (press CTRL+C) the number to the clipboard.
- Select the I have a barometer (Bray-Jennings or AAG) check box.
- On the Barometer setup tab, in the Bray/Jennings Barometer ROM ID" box, paste (CTRL+V) the number you copied to the clipboard in step 3.
- Enter values for the High Baro, Low Baro, High Voltage, Low Voltage as follows:
- Click Set.
- On the Main/Save Setup tab, click Save/reset.
- Click Close.
After approximately five minutes, barometer sensor readings are captured.